This is default featured slide 1 title
This is default featured slide 2 title
This is default featured slide 3 title
This is default featured slide 4 title
This is default featured slide 5 title
 

Apply Graphics and Decals on Bike

Bikes look ordinary. Others might do it to hide any dent or scratches from their automobile. So, if you too are looking for similar solutions or graphic installations then read this quick, professional guide on how you can apply and install the graphic kits on your bike:

Before you start

Inspect whether the plastic of the graphic kit you purchased. It looks defective, scuffed or scratched then you should get it replaced. Before you apply the graphics to your bike, you need to make sure that the bought plastic is in good condition.

For installation you will need:

• – adhesive paper tape;
• – paper knife / scissors;
• – hair dryer or heat gun;
• – degreasing agent or alcohol-water mixture;
• – squeegee (optional);

Now wash your hands as clean hands will help you prepare surface better and also keep the application area cleaners. If your hands have any dirt or oil over them then your graphics are likely to loose their stickiness.

Now you need to prepare the surface. If your bike has some pre-installed graphics or tattoos then remove it completely. You can use a hair dryer or heat gun warm up the old graphic and then clean the surface through a degreasing agent. You must not leave any sort of glue residues on the surface. Before you apply the new sticker, the bike material should be warmed up well.

Apply the Graphic:

Now place the Decal graphics over the spot you want to install them and tape down the decal on it. This will help to hold it in place. Use as much tape as you want to be comfortable. Now peel off the backing paper from the background of the decal to till its middle. Cut the peeled part and check the alignment of the decal, whether it is as you desired or not!